Need help?Do you have a question about the Ampeg SVT-4 PRO and is the answer not in the manual?
Output Power| output power rating mono-bridged at 4 ohms | 1600 Watts |
|---|---|
| output power rating mono-bridged at 8 ohms | 1200 Watts |
| output power rating 2 x at 2 ohms | 900 Watts |
| output power rating 2 x at 4 ohms | 625 Watts |
| output power rating 2 x at 8 ohms | 350 Watts |
Tone Control Range| bass control range | ±12dB @ 50Hz |
|---|---|
| midrange control range | ±15dB @ selected frequency |
| treble control range | +14dB / -19dB @ 5kHz |
Graphic EQ| graphic eq level | ±10dB |
|---|---|
| graphic eq range 33Hz | ±15dB |
| graphic eq range 80Hz | ±8dB |
| graphic eq range 150Hz | ±8dB |
| graphic eq range 300Hz | ±8dB |
| graphic eq range 600Hz | ±8dB |
| graphic eq range 900Hz | ±8dB |
| graphic eq range 2kHz | ±8dB |
| graphic eq range 5kHz | ±9dB |
| graphic eq range 8kHz | ±10dB |
Switches| bright switch | +6dB @2kHz |
|---|---|
| ultra high switch | +6dB @ 5kHz |
| ultra low switch | +2.5dB @ 50Hz -12dB @ 560Hz +1.5dB @ 5kHz |
General Specifications| signal to noise ratio | 75dB typical |
|---|---|
| compression ratio | 10:1 |
| tube complement | 12AX7 (3) |
Power Requirements| domestic power requirements | 120VAC, 60Hz, 1.4kVA |
|---|---|
| export power requirements 100/115VAC | 50/60Hz, 1.4kVA |
| export power requirements 230VAC | 50/60Hz, 1.4kVA |
Size and Weight| width | 19/17.4” |
|---|---|
| height with feet | 5.6” |
| depth | 15.5” |
| weight | 39.5 lbs |
To Next Page
