Ampler Curt - Power on the Bike

5/16
V1.1, 24.04.19
Take the 6mm hex key and adjust the perfect seat height
1. Place the bike in a way that allows you to support
yourself against a wall when siing on it.
2. Put one pedal in its lowest position.
3. Hop on and try to reach the pedal with your heel.
4. You have the perfect seat height when you are able
to place your heel on the pedal with an almost fully
stretched leg.
And you are good to go!
Adjust the seat height
Assembly
Power on the bike
Just press the power buon on the power panel,
located on the le side of the bike. The bike is
already fully charged when you receive it.
Charging the bike is like charging a laptop. Just con-
nect the bike with a standard wall power outlet (110–
240 V AC) and hook the magnetic charger plug to the
charging socket located on the power panel and let it
to charge.
Once the led on the charger turns from red to green
it has been fully charged. It takes about 2.5 hours
from drain to full.
Ampler charger will automatically stop charging when
the baery is full. There is no risk of overcharging the
baery when you forget to unplug it.
Turning the bike on
Charging the bike
6 mm