EasyManua.ls Logo

AMX NXD-1200VG - Page 2

AMX NXD-1200VG
2 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AMX Corporation reserves the right to alter specifications without notice at any time.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
036-004-2826 3/05 ©2005
AMX Corporation. All rights reserved. The AMX logo is a trademark of AMX Corporation. AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-2250-70
REV: C
3. Insert the panel-end of the Black RJ-45 Audio/Video cable into the
groove along the inside of the enclosure.
Note: The CAT5 Suppression Ferrites MUST be installed onto the
cable connected to the Modero’s Audio/Video RJ-45 connector (just
behind the connector).
4. Snap the enclosure shut with the cable inside, and you’re done.
5. Repeat this process again only when installing an additional CAT5
Suppression Ferrite (model specific).
FIG. 4
Ferrite connector location on Audio/Video RJ-45 cable
1
3
2
6 inches
To Touch
4
Connector
3
- used for Power
Connector
4
- used for RGB (Blue)
Connector
1
- used for Audio/Video (Black)
Connector
2
- used for Ethernet (White)
Panel
Ferrite
Ferrite

Other manuals for AMX NXD-1200VG

Related product manuals