Amytel AT5220 - Page 5

Getting Started
9
3. Place the handset on the base unit or
charger for charging.
CHECKING THE BATTERY LEVEL
The battery icon displays the current battery level.
= 100% full = 60% full = 30% full = Empty. Require charging.
Your handset may power down shortly if it is not charged after the battery is empty. If you are on the phone while
the battery is nearly empty, you will hear warning tones. Your call may be cut off shortly after the warning.
WHAT IS STANDBY MODE?
Your phone is in standby mode when it is idle. The standby screen displays the handset name, the signal
icon, and the battery icon.
REGISTERING YOUR HANDSET
Registration allows communication between your base unit and handset(s). If your handset is not registered,
you will not be able to make a call or use some of the functions and features on the phone.
To register your handset to an additional base unit, see Registering your handset with additional base on page
22. If your handset displays UNREGISTERED , follow the steps below to register your handset.
1. Press on the base unit for 4 seconds.
2. Press on the handset.
3. Press Up or Down Navigation keys to select SYSTEM . Press
4. Select REGISTER . Press .
5. Enter the system PIN (Pre-set: 0000 ).
6. Press 1, 2, 3, or 4 to select the base number you want. Your handset starts searching for the
base.
Registration shall be completed within 30 seconds. If registration is successful, the signal icon
displays steadily. If registration failed, repeat the above procedure.
NOTE:
Your base can register up to 4 handsets. After registering 4 handsets,
your base unit registration memory is full. If you attempt to register an
additional handset, registration will not be successful.
NOTE:
Your handset shall be already registered in the box.
NOTE:
Handset may get warm durin
g initial charge. This is normal. The handset
may take a few seconds to power up.
Getting Started
10
CHECKING THE SIGNAL STRENGTH
The signal icon displays the link status between your handset and the base unit. A steady icon means your
handset and the base unit are linked. A flashing icon means your handset and the base unit are not linked.
If you move too far away from the base unit while you are on the phone, you will hear warning tones
notifying you that your handset is almost out of range – lost link. Take your handset closer to the base unit
or your call may be cut off shortly after the warning.
SWITCHING YOUR HANDSET ON/OFF
Switching on your handset
1. Press . The handset may take a few seconds to power up.
Switching off your handset
1. Press and hold . The handset’s screen turns off.
NOTE:
If your handset has lost li
nk, you will not be able to make or receive any
call. You will also not be able to carry out many of the phone functions and
features.
NOTE:
Your handset cannot receive any call if the power is switched off.