Analog way QuickVu - Page 49

49
8.2.4 Output selecon sengs
- DVI as HDMI: DVI output content as HDMI. Audio is included,
enable or not the HDCP detecon on the output,
 display the centering test paern,
 choose to display one of the available test paern.
All changes have to be validated by pressing the ENTER buon in order to be saved
NOTE: The output status can provide you all informaon about the output in real me. This feature is
parcularly needed when HDCP is used with long cable to be sure that the communicaon is well
handled.
8.2.5 Preview features
The Preview output can display all adjustments before the TAKE.
All current layers for the Program are dened by a colorful frame on Preview. They are idened by a leer
and a number with the same color.
- Layer A: Ax, with xx of 1 to 8,
- Layer B: Bx, with xx of 1 to 8, (layer B is always keyed)

Because the number of resources available is limited, the Preview displays only one live or sll layer at a me.
The others are only idened by their colorful frame and their number.
8.2.6 Preview Id
The funcon disables all the display of ID informaon in Preview mode. The colored frames and numbers
indicang your source selecon on each layer are disabled. To set up your Preview Id:


• To assign a source to a layer, press the Layer buon, press the Source# you want to assign.
 
The source number 4 will be displayed in the Layer A.
Press TAKE to view the result on the Program screen
• To delete a layer from the Preview screen:

Press TAKE to view the result on the Program screen
• To clear all layers on your Preview screen:

Press TAKE to view the result on the Program screen
• To freeze a layer: 

Once a source is assigned to a layer, you will have access to some layer sengs in the Layer menu or direct-
ly by pressing the layer buon.
The sengs available depend on the layer selected:
- Layer adjusts: set up layer size and posion,
set up layer zoom size and posion,
 adjust a specic size (Fullscreen, 1/2, 1/3, ...),
- Transparency: adjust the layer transparency,
 adjust the Open/Close eect type and duraon,