ANCHEER
10
Installation And Adjustment
5. Install the pedals
There are a right pedal marked "R" and a left
pedal marked "L". When installing, make sure
to identify the R/L letter on the pedal bolt.
Ensure that the thread of each pedal is fully
inserted into the crank arm. Tighten the pedals
completely with a wrench. (Counterclockwise
screw the pedal marked "L" on the left side
crank. Clockwise screw the pedal marked "R"
on the right side crank.)
So far, congratulations! You have completed the assembly of the entire bike.
5.1
5.2
To Next Page
Loading...
