ANCHEER
9
Installation And Adjustment
4. Install the front wheel
Using the tool to loosen the fixing rod of the front fork and remove it (this accessory
is to prevent the front fork from being deformed during delivery).
Remove the protective washer from the hub of wheel (this accessory is to prevent
the brake from damage during delivery).
Take out the quick release skewer from Wheel and unscrew the bolt from the quic
k release.Set front wheel set into front fork. Make sure fork hanger hold onto whe el
axle, and make sure the disc put into middle of brake.Insert quick-release axle into
spring and tighten screw(Quick release nut to be at the same en d as the brake).
4.1
4.2
4.3
To Next Page
