The AN-1000X is a powered speaker which allows you to
monitor the signal from many types of input sources.
Here’s how easy it is to use
1. Place the AN-1000X at desired listening location.
2. Plug the power cord into a grounded AC outlet.
3. Plug an audio source into one of the three input jacks
on the back panel:
• LINE IN; RCA jack
• LINE IN; 1/4-inch phone jack
• BALANCED INPUT; XLR jack (*see below)
4. Set the volume knob on front panel to minimum,
then turn power switch on back panel ON (the red
LED on the front panel of the unit should light).
5. Adjust the volume bass and treble for desired sound
output.
* The BALANCED INPUT jack is set at the factory for
microphone-level inputs with 15 volts DC phantom
power. See page 7 for instructions on how to change
the configuration of this input jack.
Blank Page
10
Table of Contents
3
Thank you for choosing an Anchor Audio portable sound system. Our products
incorporate state-of-the-art design and the finest quality of materials and
workmanship. We’re proud of our products and appreciate the confidence which
you have shown by selecting an Anchor system.
I hope you’ll take a few of minutes to review this manual. We’ve incorporated
several unique features into our products, and your knowledge of how to use
them will enhance the performance and your enjoyment of the system.
David Jacobs, President on behalf of all Anchor employees
Quick Use Guide
Problems?
Consult the
troubleshooting
section on the
back page of
this manual.
To Next Page
Loading...
Need help?
General
