Accessories
8
MIC-90 Handheld Microphone
Anchor’s dynamic, balanced, low impedance microphone
with a unidirectional pick-up pattern. It has an on/off switch
and comes with a 20' cable and mic clip.
AN-1001X Companion Speaker
Unpowered speaker for use with the AN-1000X. It has a
1/4"-phone input jack and parallel input/output wire
terminals. (Designed to accept Omnimount® 25-series
mounting brackets) Speaker cable not included.
SS-250 Speaker Stand
Collapsible speaker stand. Rated load capacity 25 pounds.
(Requires SB-1 bracket.)
SB-1 Stand Mounting Bracket
U-shaped swivel bracket. Mounts to a wall, ceiling or on a
speaker stand (adapter included).
RM-1 Single Rackmount Kit
Mounts one AN-1000X in a standard equipment rack .
RM-12 Dual Rackmount Kit
Mounts two AN-1000X’s in a standard equipment rack .
SC-50 Speaker Cable
Heavy duty 50' speaker cable.
Feedback Information
5
What causes feedback?
Feedback is a ringing, howling, or shrill sound that is self-
generated by the sound system. It is the result of sound from
the speakers being picked up by the microphone(s) in use
and then re-amplified by the system. This can form a self-
sustaining loop that can damage the sound system if allowed
to continue.
To prevent feedback:
ALWAYS STAND BEHIND THE SPEAKER
WHEN USING A MICROPHONE.
CAUTION: Feedback can damage your equipment and may be
hazardous to your hearing. To avoid feedback, always make
sure volume controls are at minimum before turning unit on.
If feedback occurs, immediately reduce the volume.
To Next Page
Loading...
Need help?
General
