What to do if my Ancona Ventilation Hood doesn't turn on after installation?
If your Ancona Ventilation Hood or its LED light isn't working after installation, ensure the hood is plugged in and that the power is turned on. Check that fuses haven't blown and that all electrical wiring is properly connected.
How to improve the venting of my Ancona Slim S3D?
To improve the venting of your Ancona Ventilation Hood, ensure the distance between the stove top and the bottom of the hood is between 24 and 30 inches (61 and 76.2 cm). Also, reduce the number of elbows and the length of the duct work, and verify that all joints are properly connected, sealed, and taped.
Why is the fan weak on my Ancona Slim S3D?
A weak fan in your Ancona Ventilation Hood could be due to a few reasons. First, check that the duct size used is at least 6 inches (15.2 cm) or 3 1/4 x 10 inches (25.4 x 8.3 cm); the range hood will not function efficiently with insufficient duct size. Also, check if the duct is clogged or if the damper unit (half-circular flange) is not installed correctly or opening properly. A tight mesh on a side wall cap unit might also restrict airflow.
Why does my Ancona Slim S3D Ventilation Hood vibrate when the blower is on?
Your Ancona Ventilation Hood might be vibrating when the blower is on because it hasn't been properly secured to the ceiling or wall.
Essential safety rules for using the range hood to prevent fire, shock, and injury.
Safety requirements for proper ventilation and air flow.
Warnings and steps to prevent and handle range top grease fires.
Procedures to follow in case of a gas leak to minimize injury risk.
Guidelines and requirements for exterior duct termination.
Procedures for creating exterior ventilation, including hole creation and damper insertion.
Steps for physically mounting the hood to the cabinet or wall securely.
Detailed instructions for safely connecting the range hood's electrical wiring.
Critical information on proper grounding to prevent electrical shock hazards.
General| Body Design | Stainless Steel / White |
|---|---|
| Interference Protection | Radio Frequency Interference Protected |
| Filtration | Charcoal filter |
| Illumination | 2 × 2.55 W LED |
| Venting Size | Top or rear, 10 in. × 3 1/4 in. (25.4 cm × 8.3 cm) Rectangular |
| Power Rating | 120 V / 60 Hz (cETLus Certified) |
| Total Input Power | 106 W (100 W + 2 × 2.55 W) |
| Motor Input Power | 100 W |
| Amperage | 1.47 A |
| Speed Control Levels | 3 Speeds |
| Control | Mechanical control panel |
| Motors | Single Motor |
To Next Page
