How to fix an Ancona gc430 that won't turn on after installation?
If your Ancona Ventilation Hood or halogen light isn't working after installation, check if the hood is plugged in and that the power is turned on. Also, make sure no fuses are blown and that all electrical wiring is properly connected.
What to do if my Ancona Ventilation Hood is not venting properly?
If your Ancona Ventilation Hood isn't venting properly, several factors could be the cause. First, check if the duct is clogged or if the damper unit isn't installed correctly or opening properly. A tight mesh on a side wall cap unit might also restrict airflow. Ensure the distance between the stove top and the hood's bottom is within 24” and 30” (minimum 30” for gas stove tops). Reduce the number of elbows and the length of duct work, and verify that all joints are properly connected, sealed, and taped.
Why is my Ancona gc430 vibrating when the blower is on?
If your Ancona Ventilation Hood vibrates when the blower is on, it might not be secured properly to the ceiling or wall. Ensure it is firmly attached.
General| Power Rating | 120V / 60Hz (USA & Canada standard) cULus Certified |
|---|---|
| Total input power | 250W |
| Motor Input Power | 210W |
| Total Ampere | 2.2A |
| Levels of speed control | 3 levels |
| Air Flow | 420 CFM |
| Noise Level | 49 dB / 54 dB / 58.2 dB |
| Filtration Type | Aluminum filter |
| Interference Protection | Radio frequency interference protected |
| Number of Motor | Single motor |
| Fan Type | Single chamber quiet |
| Control Type | Electronic control |
| Illumination | 2 x 20W Halogen G4 |
Weight and Dimensions| Body design | Stainless steel |
|---|---|
| Venting Size | 6” Round |
Key warnings for installation, operation, fire, and electrical hazards.
Lists and illustrates all parts included with the range hood for installation.
Guidelines for proper ventilation system setup, duct type, and termination.
Recommended mounting distances above the cooking surface for optimal performance.
Instructions for proper electrical connection, grounding, and required power supply.
Procedures for installing hood and chimney mounting brackets and attaching the glass.
Steps for installing the damper, hanging the hood, and securing it to the wall.
Instructions for installing the decorative chimney and baffle filters.
Schematic illustrating the electrical connections and components of the range hood.
To Next Page
