3
The ALX3000 can be used with various settings to suit the user. The default settings are as follows:
1. Service and Calibration period is 365 days.
2. If the test result is “PASS”, then you have 5 minutes to start the engine.
3. If the test result is “FAIL”, the next test can be performed only after 5 minutes.
DEVICE FEATURES
SPECIFICATIONS
Model No. ALX3000
Indication of BAC 0.000% - 0.400%BAC
Sensor Fuel Cell Sensor
Warm up time 5-60 seconds
Response time Within 10 seconds at
0.10%BAC
Recovery time 10-30 seconds
Accuracy ±0.005%BAC at
0.100%BAC
Working
Temperature
-40 – 85°C
Memory Device: 500 test records
Control Box: 500,000 test
records
Mouthpieces 5 pieces included
Calibration Every 1 year
Operation
Voltage
DC 12 ~ 24v
Weight Handset: 135g
Control Box: 650g
Dimensions 146 x 60 x 28 mm
Warranty 1 Year
1. Insert a mouthpiece into the ALX3000 handset.
2. Turn on your vehicle ignition.
3. Press the “Enter” button on the handset to start the device. When it displays “Perform breath
test”, you will hear a beep sound.
4. Wait until the device finishes warming up.
5. When the device is ready for a breath test it will display “BLOW”.
6. Take a deep breath, place your lips completely around the mouthpiece, and blow steadily into it.
7. The breath sample will be analysed, and the result will be displayed.
8. If you pass the breath test, then a countdown will follow, allowing you to start your car within
this time frame.
9. If you fail, a temporary lock-out will follow, and the vehicle will not be able to start.
Note: If the amount of alcohol detected is above the set limit value, a “FAIL” message appears
on the display and a different alarm sound is produced for each alcohol concentration:
- LOW level: 3 “beeps”
- HIGH level: 1 long “beep” for 10 seconds
After the alarm, the ALX3000 will automatically lock for 15 minutes, and retests are not
permitted during this time. The next test-able time will count down and can be confirmed on the
display. All events are recorded within the ALX3000.
OPERATING INSTRUCTIONS
To Next Page
Loading...
