5
If you wish to perform a new breath test (e.g. at a driver change, please perform the following):
1. Turn off the vehicle - the free start time will be displayed on the device.
2. Hold down both the Menu (“M”) and Enter (“U”) buttons on the handset for 3 seconds.
3. ALX3000 is then blocked, and will return to standby mode.
4. New startup procedure is now active.
DRIVER CHANGE
Calibration
error 1
Calibration error Please contact us at 1300 800 200.
Calibration
error 2
Analysing time is over
60 seconds during
calibration.
Please contact us at 1300 800 200.
Violation reset
Too many violations have
been detected
Please contact Andatech at 1300 800 200.
Violation 2
The sampling process
was not successful
Please re-test with the ALX3000 again.
Low temp.
The temperature of the
handset is too low
Detach and take the handset to a moderate
temperature area. Reconnect and perform a
breath test
High temp.
The temperature of the
handset is too high
Detach and take the handset to a moderate
temperature area. Reconnect it and perform a
breath test
Err X
System error Please contact an authorised service center.
No display
message on the
handset display
Communication problem
between the handset and
control unit
Check the plugs of the connecting cable,
unplug it from the handset and reconnect
them. If the issue still persists: call an
authorised service center
Override lockout
ALX3000 is lock after
override.
Please contact Andatech at 1300 800 200.
Override period
??:??:??
On override Please contact Andatech at 1300 800 200.
Retest required
in 03:00
Request for retest. Please retest ALX3000 in random or retest
required time.
Temporary
Lockout: ??:??
Lockout when the breath
sample is over the set
limit value or frequent
FLOW error.
Please retest ALX3000 after the time shown.
Memory over
Out of memory in the
control box.
Please contact Andatech at 1300 800 200.
Service required
Over service requirement
period.
Please contact Andatech at 1300 800 200.
CAL Required
Over calibration
requirement period.
Please contact Andatech at 1300 800 200.
To Next Page
Loading...
