ANDILOG CENTOR EASY - Limits Configuration

Operating Manual – V3.39
CENTOR EASY Force Gauge
- 9 -
In the following screens, the operating mode is the same, however, in any other screen whatever the
position of the cursor:
“X”: switches to the previous screen cancelling the modifications.
“M”: switches to the previous screen and saving the modifications.
Let see the force gauge functions one by one:
1. Limits
Thresholds allow defining limits and actions achieved by the force gauge when the limit value set is
reached.
From Menu, highlight “LIMITS” and select with “TDX ” button.
From this screen you can choose to activate this feature.
Display “YES” or “NO” (using TDX and ZERO buttons) to activate or
deactivate this feature.
Once the feature is activated, the parameters are displayed
In the main measuring screen, the status line is modified: signs <<, = , >> are displayed, they display if
the value is inside or outside the limits.
LIMITS
Chan. I N O
MENU T DX
LIMITS
Chan. I Y ES
UNIT N
T1: + 0 0 0 1
T2: 0 0 0 0
DEF AU L T I N T
BEEP NO
TYPE V AL
MENU
TDX
UNIT : defines the unit chosen for the threshold
T1 : determines the value of first limit
T2: determines the value of the second limit
DEFAULT : defines if the faulty zone is inside or outside.
INT the default zone is in between, inside T1 and T2. EXT
the default zone will be not include in between T1 and T2
BEEP : beeping when values are in the default zone
TYPE : chooses on which value the threshold applied. VLI
current value, MAX maximum, MIN minimum.