ANDILOG CENTOR EASY - Display Mode; Zeroing

Operating Manual – V3.39
CENTOR EASY Force Gauge
- 6 -
3. Display mode
We describe here the screen following manufacturer settings, prepared by ANDILOG for delivery.
Note: On line 1 and line 2 you can display the following:
• VLI : current value
• MXI: Maximum
• MNI: Minimum
4. Zeroing
The “ZERO” button allows for the tare. The gauge will take into consideration the weight of
accessories (hook or plate) fixed on the sensor’s rod.
Pressing this button reset all memories, especially peak values.
NOTA: When turned on the CENTOR achieves several tests, especially to check the sensor’s good
state of health. It is possible to leave tools fixed on the force gauge, but the total weight must not
exceed 20% of the sensor’s maximum capacity.
Capacity of the
load cell
Line 1
Line 2
Measuring unit
Type of value
displayed on
line 2
Battery level
Type of value
displayed on line 1
Measuring direction
Bargraph