- 10 -
You can display the word “FAIL” or “PASS”; the setting is done in the “DISPLAY” menu.
Note: This feature allows activating a TOR output on the 15 pins connector on the side of your
device. The setting is done through the IN/OUT menu. (You can by example send a STOP signal to a
motorized test stand)
Note: If only one threshold is necessary, max value for example, enter the max or min capacity of the
sensor for the second threshold value.
2. Display
Exit by pressing the “M” button to save your parameters.
From this menu you can entirely set the main screen.
FAIL when the current
value is inside the
faulty zone
Display the position of the
value according to the
specified threshold
To Next Page
Loading...