Continuum CPU Reference
31
Operation
Power On
IMPORTANT
Before applying power to the NetController make sure all connections are secure. The
system is not designed to allow you to add I/O modules while the power is on.
The NetController has no power switch. It is assumed that it is connected to an
appropriate
Continuum
power supply module. To apply power to the system, the power
switch located on the left side of the power supply module case must be depressed.
The switch is a rocker type with each side marked according to function. Pressing the side
marked with the
I
turns the power on. The
POWER
status indicator illuminates.
To remove power, press the side marked
O
.
Once power is applied, any
Plain English
programs residing in the NetController begin
operating.
To Next Page
Loading...