Need help?Do you have a question about the andrews RSC 190 and is the answer not in the manual?
Information about the heater's design, intended use, and compliance with regulations.
Lists relevant British Standards and Codes of Practice for installation and maintenance.
Discusses the importance of safety regulations for appliance operation.
Explains the heater's resistance to Legionellae bacteria growth.
Provides physical dimensions, clearances, and diagrams for the appliance.
Guidelines for selecting a suitable installation location for the heater.
Details on flue system requirements and installation options.
Requirements for air supply and ventilation for safe operation.
Instructions for connecting the electrical supply to the auto ignition unit.
Information on water connections, quality, and necessary water treatment.
Details about the Hydrojet Total Performance System.
Specifics for water connections when using vented systems.
Specifics for water connections when using unvented systems.
Diagrams showing correct sequence for unvented systems kit.
Instructions for connecting the gas supply.
Instructions related to gas connections during the commissioning process.
Step-by-step guide for lighting the burner.
Procedure for safely shutting off the burner.
Steps to check and adjust the main burner pressure.
Instructions for lighting the burner using the auto ignition system.
Procedures for shutting off the burner for short or long periods.
Steps to check and adjust main burner pressure.
Details on the operation of auto ignition units.
Explanation of temperature stratification and its causes.
Annual cleaning and checking procedures for the burner assembly.
Recommendation for servicing the gas control valve by a qualified engineer.
Instructions for checking and cleaning the flueway and baffle.
Information on the function, inspection, and replacement of the magnesium anode.
Guidance on cleaning the storage vessel, especially in hard water areas.
Guidelines and safety precautions for descaling the water heater.
Troubleshooting steps when the water is not getting hot.
Actions to take when the pilot flame is out.
Troubleshooting steps if the pilot flame does not stay lit.
Steps to take if the burner won't light but the pilot is established.
Troubleshooting steps when the thermocouple frequently fails.
Diagnosing and fixing issues related to sooting or poor combustion.
Steps to address excessive water temperature.
Steps to address insufficient water temperature.
Troubleshooting steps for insufficient hot water supply.
Diagnosing dripping from the heater base, differentiating condensation from leaks.
Addressing rumbling noises (kettling) caused by scale formation.
Troubleshooting steps for no ignition at the pilot light.
Steps to take if the pilot lights but the main burner does not.
General| Category | Water Heater |
|---|---|
| Brand | Andrews |
| Model | RSC 190 |
| Maximum Working Pressure | 10 bar |
| Heat Exchanger Type | Shell and Tube |
| Material | Steel |
To Next Page
