EasyManua.ls Logo

Anest Iwata Supernova LS 400 entech - User Manual

Anest Iwata Supernova LS 400 entech
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
www.supernovaspray.com
ANEST IWATA Corporation
_ 3176, Shinyoshida-cho, Kohoku-ku - Yokohama, 223-8501 JAPAN - MJ T354-03 Rev.00
GB • LS_400 entech instruction manual
I• LS_400 entech manuale d’istruzioni
FR • LS_400 entech manuel d’instruction
ES • LS_400 entech manual d’instrucciones
PT • LS_400 entech manual d’instruções
DE • LS_400 entech betriebsanleitung
SV • LS_400 entech bruksanvisning
ANEST IWATA Italia S.r.l.
Corso Vigevano, 46 - 10155, Torino (Italy)
Tel. diretto +39 011 - 24 80 868 - Fax: +39 011 - 85 19 44
info@anest-iwata.it www.anest-iwata.it
ANEST IWATA Iberica
Calle de Les Teixidores, 3-5
08918 - Badalona (Barcelona)
Tel.:+34 93 32 05 993 - Fax.:+34 93 32 05 965
info@anest-iwata.es www.anest-iwata.es
ANEST IWATA Deutschland
Mommsenstrasse 5
04329 Leipzig
Telefon: +49 (0)341 241 44 30 - Fax: +49 (0)341 252 55 95
info@anest-iwata.de www.anest-iwata.de
ANEST IWATA Europe S.r.l.
Corso Vigevano, 46 - 10155, Torino (Italy)
Direct Tel. +39 011 - 22 74 402
Fax +39 011 - 22 74 000
info@anest-iwataeu.com
www.anest-iwataeu.com
ANEST IWATA Scandinavia
Ögärdesvägen 6C, 433 30 PARTILLE - Sweden
Tel. +46 (0)31 - 340 28 60 - Fax +46 (0)31 - 340 28 69
info@anest-iwata.se www.anest-iwata.se
ANEST IWATA France
25 rue de Madrid - 38070 St Quentin Fallavier - France
Tél. +33 (0)4 - 74 94 59 69 - Fax +33 (0)4 - 74 94 34 39
info@anest-iwata.fr www.anest-iwata.fr
ANEST IWATA U.K.
Unit 10 Little End Road - Eaton Socon
St. Neots - CAMBRIDGESHIRE
PE19 8JH
Tel.: +44 (0) 1480 40 54 19 Fax: +44 (0) 1480 21 76 10
enquiries@anest-iwata.co.uk www.anest-iwata.co.uk
European Sales Branches:
Designed by

Table of Contents

Questions and Answers

  • S
    Sarah RoachAug 2, 2025
    What to do if Anest Iwata Paint Sprayer has defective spray pattern?
    • S
      Stephanie ThomasAug 2, 2025
      If your Anest Iwata Paint Sprayer has a defective spray pattern, it could be due to several reasons: * The nozzle or air cap might be dirty. Clean them carefully. * The fluid nozzle may be loose. Tighten it. * The paint viscosity could be too high or too low. Dilute the paint or increase the viscosity as needed. * The fluid output might be too high or too low. Adjust the fluid adjustment knob to reduce or increase the output.
  • F
    fowensAug 7, 2025
    How to fix Anest Iwata Paint Sprayer that does not spray?
    • B
      Brittany HopkinsAug 8, 2025
      If your Anest Iwata Paint Sprayer is not spraying, consider these potential causes: * The fluid adjustment knob may be closed. Check and adjust it. * The tip hole of the nozzle could be obstructed. Check and clean it. * The paint filter might be obstructed. Check and clean it. * The non-drip component may be obstructed. Check and clean it.
  • M
    Melissa MillerAug 13, 2025
    What to do if Anest Iwata Paint Sprayer has intermittent spray pattern?
    • H
      Heather TaylorAug 13, 2025
      If your Anest Iwata Paint Sprayer has an intermittent spray pattern, it could be due to: * Air escaping from the fluid nozzle. Check, clean, and replace the nozzle if necessary. * Air escaping from the fluid needle packing. Tighten the packing. * Air escaping from the cup joint or fluid hose joint. Tighten these joints. * Dirt inside the air cap. Clean the air cap.
  • T
    Thomas ThomasAug 20, 2025
    Why is my Anest Iwata Paint Sprayer leaking?
    • M
      Melissa MasseyAug 20, 2025
      Several factors can cause your Anest Iwata Paint Sprayer to leak: * The fluid nozzle, needle set, air cap, or gun body may be dirty, damaged, or worn. Try cleaning these parts, and replace them if necessary. * The air cap could be dirty. Clean it carefully. * The fluid adjustment knob may be loose. Adjust it to secure it. * The fluid needle spring might be worn. Consider replacing it. * The fluid nozzle could be loose. Tighten it. * The needle packing set may be loose, too tight, dirty, or worn. Adjust, clean, or replace it as needed.
  • Y
    yvonnewalkerAug 26, 2025
    Why is air escaping from the air cap of my Anest Iwata Paint Sprayer?
    • I
      icarrollAug 26, 2025
      If air is escaping from the air cap of your Anest Iwata Paint Sprayer, it might be because: * The air valve, air valve seat, or air valve spring is dirty or damaged. Clean or replace them if necessary. * The air valve seat o-ring is damaged or worn. Replace it.

Summary

IMPROPER USE

1. TECHNICAL SPECIFICATIONS

2. SAFETY WARNING

FIRE AND EXPLOSION

Precautions against fire hazards and explosion risks.

PROTECTION OF HUMAN BODY

Guidelines for protecting the user from physical harm and health risks.

3. HOW TO USE

4. HOW TO OPERATE

5. MAINTENANCE AND INSPECTION

MANUAL CLEANING PROCEDURE

Detailed steps for cleaning the spray gun manually.

AUTOMATIC CLEANING PROCEDURE

Instructions for cleaning the spray gun using an automatic washer.

DISASSEMBLY PROCEDURE

Step-by-step guide for taking the spray gun apart.

INSPECTION & REPLACEMENT STANDARD

Guidelines for inspecting parts and standards for replacement.

6. TROUBLESHOOTING

GUN DOES NOT SPRAY

Troubleshooting steps when the spray gun fails to dispense paint.

INTERMITTENT SPRAY PATTERN

Addressing issues causing inconsistent spray patterns.

DEFECTIVE SPRAY PATTERN

Diagnosing and fixing problems with the spray pattern quality.

LEAKING

Identifying and resolving issues related to paint leakage.

AIR ESCAPES FROM AIR CAP

Troubleshooting air leaks from the air cap.

7. SPARE PARTS LIST

DECLARATION OF CONFORMITY

Anest Iwata Supernova LS 400 entech Specifications

General IconGeneral
BrandAnest Iwata
ModelSupernova LS 400 entech
CategoryPaint Sprayer
LanguageEnglish

Related product manuals