PRODUCT SPECIFICATION
Power Input: 1800-2000W
Voltage Input: 220-240V~ 50Hz
PACKAGE CONTENTS
1 Main Unit 1 Instruction Manual
NOTE: Confirm all parts before disposing of carton. Safely dispose of all plastic bags
and other packaging components. They may be potentially dangerous to children.
ASSEMBLY AND OPERATION
• Ensure the ON/OFF control switch is in the OFF (position “0”) position
before connecting to main power.
• Maker sure the appliance, including the plug and cord are not damaged.
• Insert power plug into a wall socket with correct power output,
220-240V AC 50Hz.
• Turn ON/OFF control switch to either:
- “ ” for Fan Only
- “I” for Low Heat
- “II” for High Heat
NOTE: When the heater is switched ON, the red power indicator light will turn ON
(make sure to turn the temperature control setting pass the midpoint, selecting a
lower setting will not turn the heater ON).
• Turn the temperature control setting clockwise to increase temperature and
anti-clockwise to decrease temperature. The heater will turn ON and OFF to
maintain the desired heat setting
• Select the oscillating control switch "0/I" located at the back of heater base
to activate the oscillation function ON or OFF.
NOTE: There is a tip-over switch attached to the base of the heater. If the heater is
not placed on a flat surface or if it is knocked over, the power to the heater will shut
down automatically.
NOTE: The heater may emit small amount of smoke and odour when used for the first time.
This is normal and caused by the lubricant on the heating element during the production
process. It is non-toxic. If the smoke and odour are excessive, use the heater in a ventilated
area. The smoke and odour should disappear after a few minutes of use.
To Next Page
Loading...
