anko ITGM-06 - Page 5

Interchangeable Massage Heads
Small ball head
Small round head
Flat Head
U-shape head
For large muscle
group
For joints and deep
muscle groups
For whole body
For spine and large
muscle groups
Note: For massage head installation, simply plug/pull to remove and replace
different massage heads
Control Panel
1. Speed indicator: 1-5 speed, in blue LED; OR
Battery level indicator: 1-5 level, in blue LED
5 lights ON
100% Power
4 lights ON
80% Power
3 lights ON
60% Power
2 lights ON
40% Power
1 light ON
10-20% Power
5 lights flashing
Battery low, require charging
2. On/Off and Speed setting button:
·Press & Hold 2 seconds to get into Standby Mode
·Short press to select speed 1-5
·Press and Hold 2 seconds again to turn OFF the massager
3. Power indicator: USB-C Charging Port
How to Charge
1. Before charging, make sure the massage gun is turned off.
2. Fully charge the massage gun for 4 hours before the first use.
3. The battery indicator flashes regularly to show it is under charging.
Note: When charging, the device cannot be turned on and used.
4. The average running time of the massager is about 1.5 hour, depending
on speed selected and the pressure applied.
5. When 5 lights flashing, it means the gun need charging.
How to Use
1. Press and hold the On/Off button for 2 seconds, the massager will get into
Standby mode.
2. Keep pressing the button to select desired speed. Speed setting will cycle
through 1-2-3-4-5.
3. Press and hold the On/Off button to turn OFF the massage gun.
4. The unit will automatically turn off after 10 minutes of operation. It is
recommended to allow the massager to cool when the enclosure is warm
to touch.
5. Restart the unit by step (1) after auto-shutdown.
Maintenance, Cleaning and Storage
1. Clean the equipment with a slightly damp cloth and dry with a soft cloth.
2. When storing or traveling, put it in the package provided.