Page 13 of 20
• When clean, gently shake the excess water from the clipper head.
• Allow the clipper to sit and air dry naturally.
NOTE: Cleaning and user maintenance shall not be made by children without
supervision.
To replace, align the tab on the back of the Clipper blade assembly with the
opening in the main body as shown, then swing closed and push in all the
way until it locks in place.
7.2 Lubrication
The Hair Clipper will need periodic lubrication to allow the blades to run
smoothly.
Use a drop of the supplied oil or sewing machine oil every few months of use
directly onto the shaving blades and trimming blades.
Apply a couple of drops to the Shaving head and pop-up trimming blades before
first use.
During use, should the Lubrication Symbol “ “ in the LED display start to
flash Red, this is an indication that the motor is running too hot and that the
blades need lubrication.
Allow the appliance to fully cool down, then add a few drops of oil before using
again.
To Next Page
