Page 16 of 20
Slide the On / Off switch forward, then gently place the nose trimmer nozzle
end into one nostril and work in a circular motion around the internal area of
the nostril cavity.
CAUTION: Be very careful not to push the trimmer too far up into the nasal
cavity as this may become uncomfortable.
Once finished, turn the unit off by sliding the On / Off switch backward, and if
required, clean the nose trimmer (refer to cleaning instructions), then repeat
the same procedure on the other nostril.
IMPORTANT: Clean the Nose Trimmer after each use.
11.2 Light
The Nose Trimmer has a small light built in to help illuminate the area being
trimmed.
This light automatically turns on when the Nose Trimmer is turned on.
12 Care and Cleaning
12.1 Cleaning
To ensure optimal trimming efficiency, the nose trimmer must be cleaned
regularly.
IMPORTANT: D
o Not use flammable liquids, chemicals, abrasive creams,
steel wool or scouring pads for cleaning.
T
he easiest and most sanitary way to clean the nose trimmer head (not the
body) with fresh, warm (not hot) water each time after use.
To Next Page
