Page 8 of 20
3 Hair Clipper - Instructions for Use
IMPORTANT: Refer to the Section “Lubrication” before first use.
NOTE: T
he Clipper Head is waterproof.
This means, other than the USB cable, the clipper head (not the body) can be
rinsed under a running tap but cannot be used whilst in the shower.
3.1 Charging the Hair Clipper
Read the Safety Instruction first.
IMPORTANT: This Appliance contains a built-in lithium-ion battery which must
only be charged using the supplied USB cable.
Always switch off and unplug the USB cable when charging is completed or
when not in use.
DO NOT allow to charge for more than 4 h
ours.
Normal charge t
akes approximately 3 - 4 hours
If any abnormality occurs during charging, (such as a burning smell or excessive
heat or even a strange sound) immediately turn off the charger and disconnect
the USB cable.
IMPORTANT: The Appliance must be fully charged before first use.
• Take the USB Cable and fully unravel it before using it to charge the
Appliance.
• Plug the small end of the USB cable directly into the bottom of the appliance.
• Plug the large end of the USB cable into your 5Vd.c. 1A USB charger (not
supplied) and switch on.
To Next Page
Loading...
