SETTINGS
NOTE: The Oven can’t dehumidify the air beyond
the humidity in your own kitchen. If you are cooking
in a humid environment, the Oven may not be able
to reach low Relative Humidity inputs.
This page refers to the Display diagram
on Page 10-11.
USING STEAM
Press the + OR STEAM CONTROLS to
adjust Steam percentage.
To stop using steam, press the STEAM
CONTROL until the percentage reaches
0 and the display says “OFF”.
If the Water Tank is empty during or before
cooking with Steam, the FILL INDICATOR
will blink. Fill the Water Tank, then press the
Fill Indicator to continue the flow of Steam.
STEAM GENERATION
You can add steam to the cooking process
by specifying a Steam Percentage (0–100%)
on the Display or in the App. This will activate
the boiler to add humidity inside the Oven.
When cooking at 100°C (212°F) or lower, the
Steam Percentage you set is interpreted
as a Relative Humidity percentage. In this
temperature range, the Oven only activates
the boiler when necessary to maintain
humidity levels, which may be infrequent.
However, when used at temperatures above
100°C (212°F), Steam is generated constantly
throughout the cooking process. In this mode,
the Oven does not measure or react to the
amount of humidity inside.
LLENAR
DESCALCIFICAR
Al vacío Temporizador
Termosonda
LLENAR
DESCALCIFICAR
Al vacío Temporizador
Termosonda
Anova_Oven_Guide_INTL_08032023.indd 16Anova_Oven_Guide_INTL_08032023.indd 16 8/9/23 5:24 PM8/9/23 5:24 PM
To Next Page
Loading...