STOP! READ BEFORE PROCEEDING
HEATING ELEMENT PREPARATION
1. Make sure the Oven is situated in a well-
ventilated area and plugged in.
2. Remove all original packaging, as well
as accessories, from the appliance.
3. Set the oven to 180°C (356°F) using the
for 15minutes
and press .
4. Allow the oven to cool. Open the door
to allow air to ventilate out.
5. Set the oven to 180°C (356°F) using the
for 15minutes and press .
6. Clean the appliance and the accessories
before first use. Refer to “Care and
Cleaning” section for details.
NOTE: The heating elements may create some
vapours and odours as their coatings burn o.
ATTACH PARTS
Install the Water Tank by sliding it from front
to back along the right side of the Oven.
Fill with distilled water. Do not fill beyond
the water line.
Attach the included Drip Tray by sliding
it under the Oven door with the open
reservoir side facing up.
NOTE: Distilled water is recommended to
minimise scale build-up and maintain
correct operating function.
Prepare the Oven before use. Refer to diagrams and information
on pages 8–12 of this guide for operation details.
Anova_Oven_Guide_INTL_08032023.indd 7Anova_Oven_Guide_INTL_08032023.indd 7 8/9/23 5:24 PM8/9/23 5:24 PM
To Next Page
Loading...