MS209xx Commands 2-2 System Commands
MS2090A PM PN: 10580-00445 Rev. C 2-3
*STB?
Title: Status Byte Query
Description: This command queries the Status Byte Register. Refer to IEEE 488.2, section 11.5.1 for
more information about each supported bit.
Query returns a NR1 Numeric response.
Supported bits:
bit 0: Not Used
bit 1: Not Used
bit 2: Not Used
bit 3: Not Used
bit 4: Message Available (MAV)
bit 5: Standard Event Status (ESB)
bit 6: Master Summary Status (MSS)
bit 7: Not Used
*WAI
Title: Wait-to-Continue Command
Description: This command causes the device to execute no further commands or queries until the No
Operation Pending flag is TRUE.
2-2 System Commands
:DIAGnostic:MEMory?
Title: Used Memory
Description: This command returns the total memory available on the instrument, the free memory,
and the memory used by the backend process in kB.
If the instrument runs into an error while retrieving system memory data, "nan,nan,nan"
will be returned as the response and a "-100" (SCPI command error) will be placed in the
SCPI error queue.
:FETCh:GPS?
Title: Basic GPS Information
Description: This command returns the timestamp, latitude, and longitude of the device. The response
is a comma-delimited ASCII response of one of the following forms: NO FIX or GOOD
FIX,<timestamp>,<latitude>,<longitude>
If no GPS fix is currently available, the first response form (NO FIX) is returned.
If the GPS does have a fix, the second response form (GOOD FIX) is returned.
<timestamp> is in ISO8601 format. The timestamp provides the 24-hour time, and will
include the year/date and/or UTC offset if the hardware supports it. If no UTC offset is
provided, the time is in UTC time.
<latitude> and <longitude> are specified in decimal degrees.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
