To Next PageTo Next Page
Need help?Do you have a question about the Ansa RS-1 and is the answer not in the manual?
Power| supply voltage | 220-240 VAC |
|---|---|
| transformer power | 3 VA |
| power relays | 12 A - @ 230 VAC |
| accessory power supply | 24VDC - 150 Ma |
| courtesy light | 40 watts maximum |
Operating Environment| operating temperature | -15 to +55 deg.C |
|---|---|
| enclosure rating | IP 44 |
Dimensions| height | 300 mm |
|---|---|
| width | 130 mm |
| depth | 74 mm |
Explains keyfob operation for opening, closing, and stopping the door.
Explains the 'Hold to Run' function for closing the door and its safety implications.
Details removing the enclosure cover and fixing the base to the wall.
Describes connecting the 240v AC power supply to the unit.
Explains connecting the motor lead to the unit's terminals.
Instructions for wiring the optional photoelectric cell safety system.
Instructions for wiring the optional LG-1 Light Grid safety system.
Wiring for wired push buttons and stop buttons.
Instructions for fitting the external aerial for improved radio reception.
Details on installing the optional ANSA Alarm System.
Description of the terminals for power connections.
Description of the terminals for motor, safety, and door controls.
Explains the system's function and procedures for testing its operation.
Detailed steps for installing the photoelectric cell sensor and reflector.
Guide on aligning the photoelectric sensor for optimal performance.
Instructions for periodic cleaning and maintenance of the photoelectric cell system.
Explains the system's function and procedures for testing its operation.
Instructions for installing the emitter and receiver tracks of the light grid system.
Guidance on aligning the safety grid system for correct operation.
Explains the AL-12 H/W system's function as an intruder alarm.
Instructions for installing the alarm module, magnet, and trip switch.
Describes how the alarm system arms, disarms, and resets.
Procedure for testing the alarm system's functionality.
Explains LED status and how to connect to a main house alarm.
Instructions for commissioning doors with Somfy motor drives.
Instructions for setting limit switches on tubular motors.
Details dip switch settings for Warning, Retract, Generator Mode, and Decode.
Explains the function of Dip switch 3 for security features and manual override.
Describes Dip switch 4 for enabling the automatic time delay self-closing function.
