Ansa RS-1 - General Operation; Keyfob Transmitter Operation

1 - General Description
The ANSA RS1 control unit is designed to operate roller garage doors fitted with single phase tubular motor drives. Equipped with “rolling
code” high security remote controls, allowing easy memorisation of up to fifteen transmitters. The unit has all the features needed for efficient,
safe and reliable operation of roller doors including built-on courtesy lamp, operating button and multi- function red indicator LED. This guide
includes information on ANSA Photoelectric Safety Beams, ANSA Light Grid Safety System, ANSA Alarm System and popular ANSA access
controls.
ANSARS-1RollerDoorRemoteControlSystem
Contents
1 Generaldescription
2 GeneralOperation
2.2 MultiChannelKeyfobs
3 FittingtheRS-1controlunit
4 ElectricalConnections
5 RS1ControlBoardOverview&WiringSchemes
6 Photoelectriccellsafetysystem(optional)
7 LG-1LightGridSafetySystem(optional)
8 AL-12AlarmSystem(optional)
9 Commissioning
10 Addingtransmitters&wirelessaccesscontrols
11 Deletingtransmitters&wirelessaccesscontrols
12 Multi-doorcontrol
13 HolidayMode
14 Faultdiagnosticsystem
15 DipSwitchoptions&Specialsettings
16 Problemsolvingguide
17 Technicalspecifications
Installationinstructions
Pleasereadtheseinstructionscarefullypriortocommencinginstallationoftheunit.Operateunitonlywhenthedoorisinfullviewand
freefromanyobstruction.Nooneshouldenterorleavethegaragewhilethedoorisinmotion.
ThisbookletcoversRS-1unitsmanufacturedfrom01.01.2010havingthePCBidentification(Seefigure8)
NOTETOINSTALLER-PLEASEENSURETHISMANUALREMAINSWITHTHEENDUSERASITCONTAINSIMPORTANTSAFETYINFORMATION
InstallationCompany:.........................................................Installer:.........................................................Tel:.................................................FittingDate:........................
2 General Operation
Your Door Supplier will recommend the ideal combination of access control and safety
options to suit each installation and program the system accordingly. As a guide, the
general operation for a fully commissioned door is as follows:
To open the door, press the button on the keyfob transmitter for one second.
The door will fully open and stop automatically at the fully open position.
To close the door, press the button on the keyfob transmitter for one second.
The door will fully close and stop automatically at the fully closed position.
Pressing the button during a door opening or closing operation will instantly stop
the door and pushing the button again for one second will reverse the original
direction.
Please note that a delay of one second is built into the operation.
AllowforthisdelayafteroperatingthekeyfobTransmitter
Multi Channel Keyfobs use one button per door, enabling control of up to 4
garage doors from one keyfob transmitter. These are available on request.
AdditionalRemoteControlReceiverModulesarealsoavailabletocontrol
automaticgatesystems,drivewaylightingandotherequipmentfrom
ANSAMultiChannelKeyfobs.
2.1 Keyfob Transmitter Operation
2.2 Multi Channel Keyfobs
·
·
·
·
Figure1
Figure2
Page1
RS1G
3