ESC
Instruction Manual
Remark: Place the antenna of the
receiver vertically with the plane!
And don't let it close to the metal
thing for assuring its sensitivity.
(see picture 1)
8.02 Installation for Gas Powered Models
9. 2.4 GHz Operation Notes
9.01 Matching (Code)
Our products are well matched in the factory, you don‘t need to match
by yourself. But if you are going to match the receiver with another
transmitter or you have to connect a new receiver or transmitter,
please follow the following steps:
• Install the battery to 2.4 GHz transmitter and shut it down.
• Insert the matching lines to the channel BIND/CH3 port of the
receiver. (Figure 1)
• Connect the receiver battery to VCC port of the receiver, on the
same time the two LED are flashing and this means the receiver
are going to the matching status.
• Press and hold the button on the transmitter, and the switch on the
power supply.
• Observe the LED on the receiver if find that the LED is not flash
anymore and that means succussful matched (This process is
about 5 sec.).
• Release the match button on the transmitter, take out the match
line.
• Install the server and then test.
• If the tests fail, please repeat the action above.
• If the tests succeeds, insert the power supply port into VCC (The
above ways of match is only suitable for 2.4 GHz products).
8.01 Installation when a Motor Controller is used
Bind Key
8. Receiver Connectivity
To Next Page
Loading...
Need help?
General
