Antari B-200 - BCT-1 Timer Cable Remote (Optional); BCR-1 Wireless Remote (Optional); Service and Maintenance

6
11. BCT-1 Timer Cable Remote (Optional)
BCT-1 Timer Cable Remote is an optional accessory for B-200 High Output Bubble Machine, please see
instruction below;
Button/Knob
Function
DURATION [KNOB]
Adjust Duration
INTERVAL [KNOB]
Adjust Interval
POWER [RED BUTTON]
Power On / Off
BUBBLE [GREEN BUTTON]
Start Bubbling
TIMER [YELLOW BUTTON]
Active Timer Mode
Note:
** You must turn on the power of the remote in order to use it.
** If the TIMER function is off, you can still press the Green button to start bubbling.
** The “DURATION” and “INTERVAL” knob are using analog signal, therefore can’t define a specific time range.
** If you encounter any problem, please contact your local Antari dealer for assistant.
12. BCR-1 Wireless Remote (Optional)
BCR-1 Wireless Remote is an optional accessory for B-200 High Output Bubble Machine, it included a wireless
remote control and a receiver. It’s ready to use, no pairing necessary, please see instruction below;
1. Plug the receiver to the connector on the back of the machine;
2. Press BLUE button to start bubbling and press RED button to stop bubbling.
** Signal range is approximately 50m in open area, it may vary depending on actual situation on site.
** If you encounter any problem, please contact your local Antari dealer for assistant.
13. Service and Maintenance
DANGER
Disconnect the power cord before starting maintenance operation!
 Always keep the machine clean.