1. Connect the ThunderboltTM cable to the ThunderboltTM port on your computer.
2. Download and install the Orion32+ software control panel and ThunderboltTM driver
from www.antelopeaudio.com/en/support/downloads (http://www.antelopeaudio.com/en/support/downloads) This
will enable you to control your
device from your computer and select all necessary settings.
3. Open your control panel by double clicking and follow the device activation procedure.
4. Connect your choice of inputs and outputs to Orion32+.
5. The guest operating system will recognize the new output audio device (Orion32+).
6. If you want to use Orion32+ through ThunderboltTM for playback and recording, open
your preferred DAW and make sure the device is selected as an input and output.
Note: Make sure your device has the most recent firmware installed. Check this by
selecting the Options panel and clicking on the Firmware Update button. See picture:
5. Front Panel Explained
To Next Page
Loading...
