individual input levels on top meter, and output levels on lower meter. It displays 64
channels at a time that are software adjustable from the software control panel.
Note: Be aware that there might be a protective film over the display, which dims the
illumination – feel free to remove it.
7. Antelope button
Hold down the Antelope button to access the Control Menu of the device, which allows
you to adjust:
1. Clock Source
2. Peak Meter
3. Monitor Trim
4. Line Out Trim
5. Line In Trim
6. SR Conversion
7. S-MUX In
8. S-MUX Out
To scroll up and down, use the Frequency up/down buttons.
To enter each one of the sub-menus, press the Frequency down button.
To confirm a chosen setting, press and hold the Frequency down button.
Note: To Restore Factory Defaults:
1. Unplug the power cable,
2. Hold down the Frequency Up and Down buttons, and plug the power cable back in.
8. Preset buttons (1-5)
Five Preset buttons store and recall your ‘favorite’ set-ups. For more information see
page 14, section 8 (Reference to Software Control Panel).
1. Save Preset
- 1. From Control Panel
- 1. Ctrl(Win) / Cmd(Mac) + Click on Preset Button
2. Ctrl + Number 1 to 5 from Keyboard
- 2. Recall Preset
1. Simply click on your choice of preset.
6. Rear Panel Explained
To Next Page
Loading...
