Need help?Do you have a question about the AnyCubic Prusa i3 and is the answer not in the manual?
Details assembly of front and back plates for the main framework.
Guides installation of right and left side plates for the main framework.
Installation of smooth rods for the Y-axis.
Mounting the Y-axis motor and related components.
Instructions for assembling the Y-axis idler wheel.
Steps to install and tension the Y-axis belt.
Details assembly of the X-axis motor on the left side.
Installation guide for X-axis smooth rods on the right side.
Assembly and mounting of the extruder unit.
Assembly of smooth rods for the X and Z axes.
Instructions for installing the X-axis belt and tensioner.
Installing the driver for the mainboard communication chip.
Guide on using slicing software like Cura for preparing prints.
General| Build Volume | 200 x 200 x 180 mm |
|---|---|
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm |
| Heated Bed | Yes |
| Bed Temperature | Up to 110°C |
| Nozzle Temperature | Up to 260°C |
| Software | Cura, Repetier-Host |
| Machine Weight | 8 kg |
| Technology | FDM (Fused Deposition Modeling) |
| Supported Materials | PLA, ABS |
| Connectivity | USB, SD Card |
To Next Page
