AnyCubic Kossel Plus User Manual

Modification for Anycubic Kossel Plus 3D Printer
To print large size object (such as φ230×200), the printer needs modifications.
1. Assembling
As page 4 in the manual, add copper spacers (C19, new part) between effector
and CFT-JBs, as the following figure shows, and fix them with HSHCS M3×20 (C02).
A
s page 5 in the manual, add copper spacers (C19) between belt tensioners
and CFT-JBs, as the following figure shows, and fix them with HSHCS M3×25 (C20,
new part) instead of HSHCS M3×20 (C02).
Please make sure C19 are in right directions.
C02
C19
C19
C20
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC

AnyCubic Kossel Plus Specifications

General

Nozzle Diameter	0.4mm
Filament Diameter	1.75mm
Frame Material	Aluminum
Heated Bed	Yes
Frame Structure	Delta
Printing Technology	FDM (Fused Deposition Modeling)
Supported Filament Types	PLA, ABS, HIPS, Wood
Connectivity	USB, SD Card
Bed Temperature	Up to 100°C
Power Supply	110V / 220V

Summary

Printer Assembly Modifications

Effector Spacer Installation

Add copper spacers (C19) between the effector and CFT-JBs, securing with HSHCS M3x20 screws.

Belt Tensioner Spacer Installation

Add copper spacers (C19) between belt tensioners and CFT-JBs, using HSHCS M3x25 screws.

Firmware Configuration Updates

Adjusting Delta Rod and Radius Settings

Modify firmware parameters: DELTA_DIAGONAL_ROD to 271.5, DELTA_SMOOTH_ROD_OFFSET to 187, and DELTA_PRINTABLE_RADIUS to 116.

Cura Slicer Settings

Cura Build Volume Adjustment

Increase Cura's maximum width and depth settings to over 230 (e.g., 240) for larger prints.

Cura Start Distance Modification

Change the 'Start distance' in Cura's expert settings from the default (3) to 0.5 for improved printing.