AnyCubic Kossel Plus - Firmware Configuration Updates; Adjusting Delta Rod and Radius Settings

Assemble the linear rails (D06) as the following figures show.
2. Firmware
Change the parameters in firmware as the following figure shows or download the
latest firmware from Google Drive
(https://drive.google.com/open?id=0B8VIB533cgdMSVMxNm43aG1OQ0U).
DELTA_DIAGONAL_ROD change 267 to 271.5 or the number you debug (Page
19 in the manual);
DELTA_SMOOTH_ROD_OFFSET change 188 to 187 or the number you debug;
DELTA_PRINTABLE_RADIUS change 115 to 116；
For the limit switches have been moved down, the height need to be adjusted
(Page 18), and you also need level the platform.
Less
than
67mm
Less
than
15mm
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC