Anycubic Kobra 2
Quick Start Guide
I.Machine Installation
The TF card of the machine comes with an instruction video.
I)lnstall frame
2)InstaII print head
3)lnstall Touch screen
4)lnstall Filament holder
5)lnstall Filament Runout
Sensor
PEI sheet
Note: Please install PEI sheet.
2.Check Before Use
1)Pulley elastic adjustment
Check if the print head is shaking. If it is, adjust the hexagonal isolation column
located underneath the print head until it slides smoothly and without shaking.
o
Print head
Check if the print bed is shaking. If it is, adjust the hexagonal isolation column
located underneath the print bed until it slides smoothly and without shaking.
Platform
The gantry's pulleys on both sides also have corresponding eccentric
isolation columns that can be adjusted.
To Next Page
Need help?
General
