AnyCubic Kossel Plus - Cura Slicer Settings; Cura Build Volume Adjustment; Cura Start Distance Modification

3. Cura
Change the width and depth to a number bigger than 230 such as 240
Change the start distance to 0.5 (3 for default) in expert config.
To print small parts, it is suggested to change the start distance back to 3.
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC
ANYCUBIC ANYCUBIC ANYCUBIC