After the firmware installs, the radio will proceed to its welcome screen and then
to its normal screen showing frequencies and etc. You must now re-boot the
CPU for the update to take place.
Turn the radio off. Press and hold both the PTT button and the PF1 button
(located just below the PTT button), while powering on the radio. The screen
will ask for you to Confirm. After the CPU re-boot, the screen will return to the
setting of the time zone, date and local time. These are set via the keypad as
described in the owner's manual.
It is now time to re-install your saved code plug using the newest version of the
Computer Programming Software (CPS).
To Next Page
Loading...
Need help?
General
