To Next Page

To Previous Page

Installation

Do not place the monitor on an unstable cart, stand, tripod, bracket, or table. If the monitor falls, it can injure a

person and cause serious damage to this product. Use only a cart, stand, tripod, bracket, or table recommended by

the manufacturer or sold with this product. Follow the manufacturer’s instructions when installing the product and use

mounting accessories recommended by the manufacturer. A product and cart combination should be moved with care.

Never push any object into the slot on the monitor cabinet. It could damage circuit parts causing a re or electric

shock. Never spill liquids on the monitor.

Do not place the front of the product on the oor.

If you mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow the kit

instructions.

Leave some space around the monitor as shown below. Otherwise, air-circulation may be inadequate hence

overheating may cause a re or damage to the monitor.

To avoid potential damage, for example the panel peeling from the bezel, ensure that the monitor does not tilt

downward by more than -5 degrees. If the -5 degree downward tilt angle maximum is exceeded, the monitor damage will

not be covered under warranty.

See below the recommended ventilation areas around the monitor when the monitor is installed on the wall or on the

stand:

Questions and Answers:

Need help?

Do you have a question about the AOC 24B2XHM and is the answer not in the manual?

AOC 24B2XHM Specifications

General