28
Extra
Exit Enter Select
Extra
Logo Projector
AutoInput Select
Red
Green
Blue
50
0
0
Medium
Resolution: 3440(H)x1440(V) SDR
H.Frequency: 44 KHz
V.Frequency: 30 Hz
Exit Enter Select
Extra
Image Ratio
DDC/CI
Reset
Wide
Yes
No
Off Timer
0
Resolution: 3440(H)x1440(V) SDR
H.Frequency: 44 KHz
V.Frequency: 30 Hz
Input Select
AUTO/HDMI1/HDMI2/DP/
USB C
[1]
Select Input Signal Source
Logo Projector O/Low/Medium/Strong It’s projection logo function.
Red 0 ~ 100 Red gain from Digital-register.
Green 0 ~ 100 Green gain from Digital-register.
Blue 0 ~ 100 Blue gain from Digital-register.
O Timer 0-24hrs Select DC o time
Image Ratio
Wide / 4:3 / 1:1 / 17"(4:3)
/ 19"(4:3) / 19"(5:4) /
19"W(16:10) / 21.5"W(16:9)
/ 22"W(16:10) / 23"W(16:9) /
23.6"W(16:9) / 24"W(16:9)
27”W (16:9)
Select image ratio for display.
DDC/CI Yes or No Turn ON/OFF DDC/CI Support
Reset Yes or No Reset the menu to default
Note:
[1] : The device must support USB C(DP Alt) function.
The USB C (DP Alt) function is disabled by default when you use it for the rst time or reset the OSD menu. You can
enable it again in either of the following methods:
1) The display switches on and o twice in total.
2) On the OSD menu, set USB under OSD Settings to the disabled state.
To Next Page
Loading...
