20
OSD Manual Setting
Channel Search
This setting is only available in TV mode.
1
M U
/
Exit
EN
Press MENU/EXIT to call out MENU.
2
Press ▲/▼ to select “Channel ” , and press OK.
3
Press ▲/▼ to select "Tuning mode", and press OK. Select the mode of TV signal as Cable or Air.
4
Press ▲/▼ to select "System standard", and press OK. Set as NTSC-M, Auto, PAL-M or PAL-N. Advise please do not change
this item after auto search action.
5 Press ▲/▼ to select "Auto Search", and press OK.
6 Press MENU/EXIT to exit.
The submenu of Channel shows as below:
Channel Setting Items Description
Program No. Shows the current channel number.
Tuning mode Select the mode of TV signal as Cable or Air.
System standard
Can set as NTSC-M, Auto, PAL-M or PAL-N .
Note: Please do not change this item after auto search action.
Auto search
Select “Auto Search” to search all signaled channel; when the searching is complete, it stays at the first channel with
signal and all channels that have been located are stored. If you would like to stop “Auto Search” during the process,
simply by pressing the MENU/EXIT button.
Fine tuning Fine tunes the frequency of current channel.
AFC
"AFC" can be set to ON or OFF. Set to ON, the TV will search signal automatically; when there is any offset in the signal,
will automatically adjust the channel to the correct frequency.
Skip
"Skip" can be set to ON or OFF. When it is set to ON, a channel can be skipped by pressing the switching button on the
remote control or on the front panel.
M U
/
Exit
EN
Move Select Exit
Channel
Tuning mode
System standard
Fine tuning
Auto search
AFC
Skip
Program No.
Cable
NTSC-M
0
On
Off
3
English
To Next Page
Loading...
Need help?
General
