11
English
Remote Controller
Buttons located at the right side of the TV will operate the same as these buttons on the remote controller�
Ypbpr
Back
Source
VOL
C H
Mute
Display
Zoom
Freeze Picture
Sound
Nicam
Menu
Sleep
TV
AV
HDMI
PC
Button Description
Power Switch
Press this key to power on and off your TV set. Your product enters the
power saving mode rather than fully power off. Switch off the AC power of
unplug the unit to fully disconnect power to your TV set.
Ypbpr
TV
AV
HDMI
PC
TV/AV/HDMI
PC/Ypbpr
Press the TV/AV/HDMI PC/Ypbpr key to select input directly.
PR
0-9
Press any number key among 0-9 to select desired TV channel after 3~5
seconds.
-/--
Fast access to multi digit channels like ch24, ch95, ch139 etc. Press the
key and then input a number.
Back
Back
Press this key to go back to the last TV channel or input source.
USB: Used to switch into folder for music playback.
Source
Signal source
Press this key to show the table of available input sources.
Note: Not available when the input source is USB.
Mute
Mute
Press this key to mute your TV sound. Press it again or press the
volume + key to cancel mute.
VOL
Volume +/- Press this key to adjust volume of your TV set.
C H
Channel +/-
Press to select the previous or next TV channel. Press and hold either of
the two keys +/- to fast switch among channels.
Display
Display
Press to display the current signal information.
Multimedia: Press to display the JPEG in full screen.
Sleep
Sleep
Press repeatedly to cycle through the available sleep timer from
0~180 minutes. Sleep timer can be set to 5, 10, 15, 30, 45,60, 90,
120,180minutes.
Press the up/down/left/right arrow keys respectively to select available
options or adjust the OSD menu settings.
Multimedia: Use left/right keys to switch between previous/next pictures
while playing a slideshow or Switch between previous/next tracks when
playing an audio file.
TV: Use up/down key to change channels. Use left/right key to change
volume.
OK
Press the OK key to confirm your selection or to adjust the OSD menu
settings.
Zoom
Zoom
Press this key repeatedly to view available aspect ratios of your TV set.
Available aspect ratio are: wide mode, normal mode, zoom 1, zoom 2;
For computer input: normal mode and wide modes.
Menu
Menu
Press Menu key to display/close OSD menu or return to previous OSD
menu.
Multimedia: This key is used for the Exit function.
Stereo
Select mono or stereo if stereo broadcast is available.
Note: Effective only when RF input is selected.
Play/Pause,
Stop,
Next/Previous.
Control key available for multimedia operation:
:Switch between previous/next pictures when playing a slidshow.
:To START/STOP playing slide show/music.
:To STOP playing slideshow and go back to the previous menu or
to stop music playback.