AOIP TC6621 - Data Configuration; Default Value Points Configuration

Calibrated sensors D
NTA47230-300A6 77 / 101
D.4 Configuration of default value points
The configuration of default value points is performed in the configuration/Points menu, obviously providing the default
values mode has been confirmed.
 Using the F1 key, select the configuration/Points menu.
 Confirm using the VAL key.
 Using the F1 key ( ) add a new value line to the table.
 Using the navigation keys ( and  ), select the digit that requires editing.
 Using the navigation keys ( and ), increase the value of the selected digit.
 Confirm the line using the VAL key.
You can edit a value already recorded:
 Using the navigation keys ( and ), select the line requiring editing.
 Press the navigation key () to make editing possible.
You can delete a value already recorded:
 Using the navigation keys ( and ), select the line requiring deleting.
 Press the key to delete the line.
Notes:
A maximum of 100 values can be entered.
This table of values is also used for the Synthesizer mode; consequently all changes to this table entail a change to the
synthesizer values.