Installation
To install the monitor on your host system, please follow the steps below:
Steps
2 2-1 Connect VGA Cable (Only VGA-input model)
3 Insert the power cable of adapter into the power port at the back of the Monitor,
4 Turn on the monitor first, then the computer. This sequence is very important.
5 If the monitor does not function properly, please refer to the troubleshooting section to
1 Turn off your monitor and unplug your computer’s power cord.
a Make sure both the monitor and computer are powered-OFF.
b Connect the VGA cable to the computer.
2-2 Connect HDMI Cable (Only HDMI-input model)
a Make sure both the monitor and computer are powered-OFF.
b Connect the HDMI cable to the computer.
then plug the adapter into a nearby electrical outlet.
diagnose the problem.
In order to prevent damage to the monitor, do not lift the monitor by its base.
6
English
To Next Page
Loading...
