AOR AR8000 - Page 3

AR8000 operating manual
3
6-6 Correcting incorrect frequencies after input ........... 35
6-7 Changing a frequency using the UP/DOWN keys .. 36
6-8 Changing frequency using the [DIAL] .................... 36
6-9 Changing frequency step (AUTO) ......................... 37
6-10 Step offset ............................................................ 39
6-11 Changing receiver mode (AUTO) .......................... 40
6-12 Attenuator ............................................................ 42
6-13 Band scope .......................................................... 43
7 Memory banks & channels ................................. 44
7-1 Storing receive data into memory .......................... 45
7-2 Memory recall ....................................................... 46
7-3 Transfer of memory channels to VFO ................... 47
8 Editing, copying & moving memories ............... 47
8-1 Memory over-write ................................................ 47
8-2 SET EDIT-CH, copying, moving & editing ............. 48
8-3 Memory copy mode .............................................. 48
8-4 Memory copy alternative method .......................... 50
8-5 Memory move mode ............................................. 50
8-6 Memory swap mode ............................................. 51
8-7 Memory change mode .......................................... 53
8-8 Deleting memory channels & banks ...................... 56
8-9 Deleting individual memory channels .................... 56
8-10 Deleting complete memory banks ......................... 56
9 PASSWORD protection of banks ....................... 57
9-1 When the password is first used ........................... 57
9-2 Password access to banks ................................... 58
9-3 Disabling password protection .............................. 58
9-4 If you forget your password .................................. 59
10 SCANNING .......................................................... 59
10-1 Outline introduction to scanning ............................ 59
10-2 Outline of EXPERT facilities ................................. 60
10-3 Scanning considerations ...................................... 60
10-4 Scanning a memory bank ..................................... 61
10-5 Scanning a single memory bank ........................... 62
10-6 Memory bank linking ............................................. 62
10-7 Specifying memory bank linking ........................... 63
10-8 Scanning unlinked banks ...................................... 64
10-9 Scan channel PASS (lockout) ............................... 64
10-10 Memory PASS while scanning .............................. 64
10-11 Memory PASS using memory recall ..................... 64
10-12 EXPERT scan options .......................................... 65
11 SELECT SCAN .................................................... 69
11-1 Select scan while in scan mode ............................ 70
11-2 Select scan while in memory recall ....................... 70
11-3 Select scan using the menu .................................. 71
11-4 Select scan "new" channels using the menu .......... 72
11-5 Deleting individual select scan channels ............... 73
11-6 Deleting all select scan channels .......................... 73
11-7 Start, pause and cancel select scan ...................... 73
12 Priority operation ............................................... 74
12-1 Engaging priority operation ................................... 74
12-2 Changing priority channel parameters .................. 75