APEC PERMEATE-PUMPED R.O. SYSTEM - Plastic Compression Nut Fitting with Built-In Sleeve; Quick-Connect Fitting

2. Plastic compression nut fitting with built-in sleeve (comes with 1 insert, 1 nut)
Fig. 11A
How to connect: - See Fig. 11A. Slide the compression nut onto the tubing.
- Insert the “insert” into the tubing.
- Insert the tubing into the opening of the fitting.
- Slide the nut up, then tighten nut with a wrench. No Teflon tape!
3. Quick-Connect fitting
(no insert, sleeve, or nut)
Fig. 11B
Fig. 11C
How to Connect: - See Fig. 11B. Simply push the tubing into the Quick-Connect fitting.
- No inserts, sleeve, or nuts are needed to secure the connection.
- No Teflon tape!
To Disconnect: - See Fig. 11C. Push in and hold down on the collet ring around the
base of the fitting, then pull out tubing.
2
free drinking water.com
How to connect: - See Fig. 11. Slide the compression nut onto the tubing.
- Slide the plastic sleeve onto the Clear tubing.
- Insert the “insert” into the tubing.
- Insert the tubing into the opening of the fitting.
- Slide the brass nut up, then tighten nut with a wrench.No Teflon tape!
(An extra metal sleeve is provided in case you need to connect your own metal tubing.
Use Teflon tape if connecting metal tubing.)