20
5) Check for leaks!
6) Drain the first tank of water (through faucet) to flush out the new membrane! The 2
nd
tank
of water is ready for use.
Fig. 14A
Fig. 14B
How to Replace Stage-5 Carbon Filter:
Replace this last filter at the same time you replace the stage-4 membrane.
1) Remove the OLD filter: See Fig.14 A. Disconnect the output tubing from point H. Remove the
T-fitting from filter’s Left hand port. (point J). Discard the used filter.
2). The new Stage 5 carbon will come with two end plugs on the stage 5 filter that has to be
removed before inserting the tubing. Please refer to Fig. 1A on page 4 for removal instruction.
3) Use some mild bleach solution to rinse the Tee-Fitting and Tubing end. This is to prevent
contamination.
4) Connect the Tee-Fitting to point J and pure water output tubing to point H. Make sure the
“FLOW ” on the filter is pointing to the pure water output direction. Only this filter change
needs bleach sanitizing. Do Not apply chlorine/ bleach in anyway to Membrane for it will
damage the membrane!
5) Check for leaks!
* * * End Filter Change Section * * *
To Next Page
Loading...
Need help?
General
