Table of Contents
© 2014 Apeks
NOTE: The terms “Hook & Loop” are used throughout this manual. Hook & Loop is commonly
known as Velcro®, which is a trademarked brand of hook & loop. Some of the BC components
have hook & loop attachments, including the cylinder band, weight pouch aps and inator
hold down.
MOUNTING A WTX-D BUOYANCY CELL USING THE WTX HARNESS AND
UNIVERSAL CYLINDER BANDS
A buoyancy cell may be attached directly to an Apeks WTX harness using universal cylinder bands.
Using optional 3/4” book screws (PN 388113, sold separately) will help keep the buoyancy cell and WTX
harness held together while assembling the cylinder bands.
1. Set the buoyancy cell on a at surface with the zipper
side face up. Insert the cylinder band through the upper
left oval grommet hole with the hook and loop side of
the band facing down towards the buoyancy cell.
NOTE: The WTX harness can accommodate single or twin cylinder WTX-D buoyancy cells.
To Next Page
Loading...
