Standard Install - RF Input / Output
Connect antenna wire to RF ANTENNA IN on the rear of the
DT502. Connect the supplied coaxial cable wire from the
CH 3/4 terminal (RF Out) to RF ANTENNA INPUT on the rear
of your TV.
To view, tune Ch 3 or 4 on your TV, choose the channel that
does not have an active or strong signal. Slide the CH 3/4
switch located on the rear of the DT502.
QUICKSETUP
RF Coaxial cable
to your TV
Over-the-air Antenna
ANTENNA IN TV OUT
The DT502 is equipped with a shared analog pass-through and it provides a way for you to receive analog
broadcast without using a splitter. The TV Out (RF Out) serves both as the Channel 3/4 output and as the
analog pass-through output. The output from this connector depends on if the unit is On (active) or it is in
Standby (sleep) mode.
This table illustrates the different output from the RF Out connector.
Power Indicator
Light
TV Out Mode
(RF Out)
Standby
(Sleep)
On
(Active)
Actual Output
Red
Analog Pass-through
Green
NTSC CH 3/4
RF signal with analog
programming from analog broadcast
stations
Analog RF signal in channel 3 or 4
converted from digital programming
contents broadcasted by digital
stations
Please follow the procedure below when using
Analog Pass-Through
1. Make sure the converter box is in Standby mode – the power
indicator light should be red; otherwise, press the Power button
on the converter’s remote control.
2. This step only need to perform once after connection and it is
only require if you did not scan the local channel before – scan
analog channels by following the instruction of your TV. It is the
same as connecting your TV directly with an antenna.
3. You must use the remote control from your TV to change
channels.
To Next Page
Loading...
